Adrenaline Kick X8, X9, X11: Display Settings & Unlock Instructions

X8 Scooter P Settings

What Can I Do with Throttle Setting

There are two buttons on the Scooter throttle: Power and Menu, allow customers to adjust features like cruise control, zero-start / kick-start, and speedometer units (mph/kph), release maximum speed or the like. Read on and learn how to access P-settings for LCD finger throttles, which you can adjust, and which presets you should not mess with.

Disclaimer: This P-settings database is based on factory default settings, change p-settings at your own risk; check the local laws before doing so! 

Enter the P Setting Menu

How to Access Escooter P-Settings

Settings on the X9 scooter may slightly differently, but generally the same steps to access the menu:

- Power on your scooter.

- Long press the Power & Function button at the same time to enter the menu setting, screen displays “P0”.

- Press the Function key to toggle through the setting items of P0-P2.

- Use the Power button to get to the P* setting.

- Press the Function key to adjust required value.

- Press the Power button to exit the P* setting item.

- Hold the Power & Function button at the same time to save & exit the menu settings.

P-Settings on X8 Scooters

P-settings allow scooter riders to customize their ride on scooter. The 4 programmed features as below:

P0: Speedometer units (km/mile) switch — Kilometers = 0 (default) | Mile = 1

P1: Cruise Control setting — Cruise On 1 (default) | Non-cruising = 0

P2: Startup mode setting(kick-to-start or zero-start) — 0 start = 0 | Non-zero start = 1 (above 3km/h, default)

P4: 3 gears maximum speed setting — Speed limit 20KM/H = 20 | Speed limit 25KM/h = 25 Unlimited speed = FF 4

X9/X11 Electric Scooter P Settings

The X9/X11 Scooter parameter P4 is hidden. 

Press Power & Function key at the same time to enter the menu setting, and the screen displays “P0”

- Press Function key to switch to the P1 setting item;

- After holding the brake lever, press and hold the Function button for 2 seconds to enter P4 to release the brake lever;

- Press the Power button to enter the P4 setting item;

- Press the Function key to set the required P4 value, the specific values are shown in the previous section; (when the third gear speed is adjusted to FF unlimited speed, the second gear speed is 20km/h; when the third gear speed is adjusted to the speed limit 20/25km/h , the second gear speed limit is 15km/h)

- Press the Power and Function button at the same time to save & exit the P menu settings